Process Sensors Corporation Transmitters are
used routinely in various locations in the manufacture
of panel board products. These locations include
incoming green wood, blenders, dryers and forming
line. Moisture is always measured. Resin and
wax can also be measured at the same time.
Generally, a Transmitter is located after
the dryer. The Transmitter is often placed
over a conveyor, usually at a distance of
about 12 inches from the product.
When installing a Sensor, it is important
to keep environmental temperature in mind,
especially after oven outlets. If the temperature
is above 60°C, it may be necessary to
cool the Transmitter with air or water.
Calibrations for most wood products have
already been determined by Process Sensors
Corporation so that the Transmitter is delivered
pre-calibrated. Typical accuracies are ±
.2 for moisture and higher for resins and wax.
For more detailed information regarding wood
products and their applications, please
fill
out the following form. |
